Appendix; Troubleshooting - Abus eyseo. TV7206 Guide D'installation

Appendix

A. Troubleshooting
Status LEDs
Condition
Loading system after power on
During booting procedure
After network is setup (system up)
During the upgrade firmware process
Enable Audio
Resetting and restoring
At the back side of the network videoserver is a button. Press this button to reset the system or restore
the factory parameter settings. Sometimes the normal system status can be restored by a reset. If you
have further problems following a reset, restore the factory parameter settings and reinstall and
reconfigure the system.
Reset
button
RESET:
Press the reset button with a pointed object.
RESTORE:
1. Press the button continuously.
2. Wait for all LEDs blink fast.
3. Release the reset button.
LED color
Blink green twice and steady red
Steady green and red
Blink green every second and steady red
Blink green every second and fast blink red
Fast blink green and blink green every second
If
settings are restored, all the previous
settings are deleted. The system can
be reset or restored.
37
the factory parameter