Hardware Installation; Installation In The Ethernet; External Connectors - Abus eyseo. TV7206 Guide D'installation

Hardware installation

To prevent the risk of electric shock, first connect the socket of the transformer to the
videoserver before inserting the transformer into the mains socket.
When you switch on, the green LED on the front lights up and the start procedure begins. During the
start procedure, both LEDs are active for a short time. Then the red LED is active continuously. After
you define the IP address, the green LED flashes once a second. For troubleshooting hints, see
Appendix.
Consult your dealer for the correct installation of peripheral devices.

Installation in the Ethernet

Make sure that the videoserver is directly connected to a PC (cross-link cable) or via a switch/hub to
the network. Now connect the network adapter of the videoserver to the mains network. When the
videoserver is correctly connected to the network, the blue LED on the front lights constantly. If no
network is available, the videoserver switches to WLAN mode.

External connectors

Connections at front and back side
12VDC
I/O-connector
Ethernet
I/O-Port
connector
1 : Power
2 : Ground
3 : Digital input
4 : Digitaler output
5 : RS485-A (Plus +)
6 : RS485-B (Minus -)
Make sure that all accessories and articles
listed above are present in the scope of
delivery. Depending on application, an Ethernet
cable may be required. This Ethernet cable
must meet the specifications of UTP Category
5 (CAT 5) and must not be longer than 100
meters.
Status Reset
LEDs button
6
BNC video Audio input
input