Abus eyseo. TV7206 Guide D'installation page 84

For higher-quality pictures
For best video quality, set "Fixed quality" to "Detailled" or "Excellent" and the "Max frame rate" so that
it corresponds to the bandwidth of your network. If your network is slow and you get "broken" images,
go to the TCP protocol under Connection Type and select a more suitable transmission mode.
Pictures can also be affected by a time delay due to a slower connection. The more users in the
network, the greater this time delay.
For high frame rates with high-quality pictures
If you have a broadband network, set "Constant bit rate" to middle or higher and leave "Constant bit
rate" unchanged. You can also set the bandwidth according to the actual network speed or the frame
rate. Start with 30 frames per second and reduce this setting until you get the best performance.
However, do not reduce it to less than 15 frames per second. If the picture quality is not improved,
select a lower setting for "Constant bit rate".
Protecting the Dual-stream videoserver with a password
Root password
The Dual-stream videoserver is supplied with no password defined. Using this password, all users
have access to the Dual-stream videoserver, including its configuration, as long as they know the IP
address. If other users are to have access to the Dual-stream videoserver, you should therefore
assign a password to the videoserver. To activate protection, enter a new password. The administrator
is identified with this password.
17