Solving Common Dishwashing Problems - Whirlpool 980 Série Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour 980 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Solving Common
Dishwashing Problems
Following is a convenient checklist for handling minor performance problems. Go over this
list before calling for service. If you are unable to solve your dishwasher's problem, see the
"Requesting Assistance or Service" section.
Solution chart
PROBLEM
CAUSE
Food soil left
Improper loading
on dishes
Water temperature
too low
Use of incorrect, too
little or ineffective
detergent
Detergent cakes in
dispenser
Insufficient fill due to
low water pressure
Slowdown of wash
arm due to high suds
Spotting
Hard water or high
and filming
mineral content in
water
Water temperature
too low
Use of incorrect
detergents
SOLUTION
Follow loading instructions.
Use the High Temp Wash option. Do not use
the Low Energy Rinse option. If needed, turn
home water heater up to ensure water entering
dishwasher is 120°F (49°C) minimum. See the
"To check water temperature" section.
NOTE:
In some cases, loads may not dry as well
when using the High Temp Wash option.
Use recommended dishwasher detergents
only. See the "Using the Dispensers" section.
Never use less than one tablespoon per load.
Detergent must be fresh to be effective.
Always store detergent tightly closed in a
cool, dry place.
Use fresh detergent only. Do not allow detergent
to sit for several hours in a wet dispenser. Check
dispenser for caked detergent. Clean dispenser
when caked detergent is present.
Home water pressure should be 20 to 120 pounds
per square inch (psi) (138 to 838 kPa) for proper
dishwasher fill. A booster pump on the water
supply may be necessary if pressure is too low.
Never use soap or laundry detergents. Use
recommended dishwasher detergents only.
Use rinse agent to help prevent spotting and
filming. To remove hard water film, see
"Removing spots and film" at the end of
this section.
Use the High Temp Wash option. Do not
use the Low Energy Rinse option. If needed, turn
home water heater up to ensure water entering
dishwasher is 120°F (49°C) minimum. See the
"To check water temperature" section.
NOTE:
In some cases, loads may not dry as well
when using the High Temp Wash option.
Use recommended dishwasher detergents only.
continued on next page
23

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Du980qpdb5Du980qpdb6Du980qpdq5Du980qpdq6

Table des Matières