Pressure Sensor - Philips Sonicare FlexCare Platinum Mode D'emploi

Battery status (when handle is not on charger)
- 1 yellow LED indicates a low charge.
- 3 green LEDs indicate a full charge.
Note: If you hear a long beep and the yellow LED of
the battery level indicator flashes, your Sonicare will
turn off until placed on the charger, where it will start
to recharge.
Note: To keep the battery fully charged at all times, you
may keep your Sonicare on the charger when not in use.
Features

Pressure Sensor

This Sonicare model comes with the Pressure Sensor
feature activated. The Pressure Sensor works in all
3 modes and at all 3 intensity levels. To deactivate or
reactivate the Pressure Sensor feature:
1 Place the handle with a brush head attached on
the plugged-in charger or sanitizer.
2 Press and hold the power button and the
mode button for 2 seconds.
, You hear 1 beep to indicate the Pressure Sensor
has been deactivated.
, You hear 2 beeps to indicate the Pressure
Sensor has been activated.
Quadpacer
- The Quadpacer is an interval timer that has a short
beep and pause to remind you to brush the 4 sections
of your mouth. Depending on the brushing mode
you have selected, the Quadpacer beeps at different
intervals during the brushing cycle. The Quadpacer
works in all 3 modes and at all 3 intensity levels.
EngliSh
11