Control Panel Features - Krups XP6025 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

KR_ESPRESSO_XP6025_NAFTA_8080011600-02 03/07/12 17:49 Page11
p. 1 cup espresso filter
The cup size is identified on the bottom of the filter by the marking
cup of espresso using ground coffee, a compact paper pod or a soft paper pod.
q. 2 cup espresso filter
The cup size is identified on the bottom of the filter by the marking
2 cups of espresso using ground coffee. It cannot be used with 2 pods at the same time.
r. Espresso dosing spoon
Well-leveled, it allows you to measure the quantity of coffee required for a good espresso.
s Ground coffee press
The ground coffee press allows you to carefully tamp the coffee in the filter.

CONTROL PANEL FEATURES

The letters refer to the product description on page 9.
h1. Pre-programmed 1 cup espresso button:
This button allows you to program a quantity of coffee corresponding to 1 cup (approximately 50 ml in a
pre-set dose, approximately 150 ml as a maximum dose) depending on the quantity pre-programmed.
Coffee production is stopped automatically after the pre-programmed amount has been dispensed.
h2. Pre-programmed 2 cup espresso button:
This button allows you to program a quantity of coffee corresponding to 2 cups (approximately 100 ml in
a pre-set dose, approximately 250 ml as a maximum dose) depending on the quantity pre-programmed.
Coffee production is stopped automatically after the pre-programmed amount has been dispensed.
IMPORTANT
It is an intermittent button (automatic return).
h3. TEMPERATURE SELECTION button:
For the water to remain at an ideal temperature for making your preparations, the TEMPERATURE
SELECTION button must be positioned to the left for espressos or hot water
steam
.
h4. TEMPERATURE light:
This light indicates:
a) Light flashes = the espresso, hot water or steam mode is in progress
- Light is solid = the espresso, hot water or steam mode is ready to dispense
b) That the tank is empty (flashes quickly)
c) That the rotating control button should be set to PENDING (
(flashes quickly)
h5. START/STOP button
Turn the button to the right (I) to turn the machine on – (the TEMPERATURE light (h4) comes on right
away) and to the left (O) to switch off.
. This filter allows you to prepare 1
. This filter allows you to prepare
, ,
) during heating of your appliance
English
and to the right for
11

Publicité

Table des Matières
loading

Table des Matières