Changing The Fuse In The Car Charger Adapter - SilverCrest SFA 40 A1 Mode D'emploi

The hands-free set cannot be paired with a mobile
phone
Check whether the Bluetooth
♦
mobile phone .
♦ Check whether the hands-free set is switched on .
♦ If you use multiple mobile phones, ensure that there is only one
active connection with a mobile phone .
♦ Make sure that the hands-free set is no more than 10 metres
from the mobile phone and that there are no barriers or elec-
tronic devices between them .

Changing the fuse in the car charger adapter

There is a fuse in the car charger adapter
on-board power supply . If the device no longer works, check the fuse
and replace if necessary .
♦ Open the car charger adapter
(C) carefully anticlockwise with a pair of pliers and carefully
removing it .
♦ Remove the plug tip (B) from the fuse (A) and pull out the fuse .
♦ Now insert a new type F2AL 250 V fuse into the car charger
adapter
of the fuse and screw the previously removed screw insert (C)
back in .
■ 20 │ GB │ IE
, fit the plug tip (B) onto the slightly protruding end
®
function is activated on your
to protect the vehicle's
by turning the screw insert
SFA 40 A1