Handling And Use; Fitting The Car Cradle; Fitting The Suction Cup - SilverCrest SKHU 2 B2 Mode D'emploi

Car cradle with suction cup
▯
(consisting of two parts)
Car USB adapter 9
▯
Charging cable r
▯
These operating instructions u
▯

Handling and use

Fitting the car cradle

Unscrew the screw ring 4 anticlockwise from the
♦
car cradle.
Place the screw ring 4 over the ball joint 3 and
♦
press the ball joint 3 into the ball joint socket 5
(see fig. C).
Screw the screw ring 4 clockwise onto the ball
♦
joint socket 5 until tight

Fitting the suction cup

Ensure that the surface to which you wish to attach
the suction cup is clean, dry and free of grease.
Ensure that the suction cup locking lever 2 has been
released.
Press the suction cup 1 firmly against the wind-
♦
screen and push the suction cup locking lever 2
upwards. This creates suction, and the suction cup 1
is pulled tightly against the windscreen.
│ GB │ IE │ NI
■ 12
C)
SKHU 2 B2