Inserting Your Mobile Phone Into The Car Cradle - SilverCrest SKHU 2 B2 Mode D'emploi

You can use the 360° rotating ball joint 3 to ad-
♦
just the car cradle horizontally and vertically to suit
your requirements. Loosen the screw ring 4 slightly
to make it easier to adjust the ball joint 3.
To remove the suction cup 1 from the windscreen,
♦
pull the suction cup locking lever 2 downwards
and lift the small tab on the edge of the suction cup.
Inserting your mobile phone into the
car cradle
♦
Back
Place your mobile phone on the supports 8 of the
♦
car cradle.
Push the car cradle fixer grips 6 inwards until the
♦
mobile phone is held firmly in place.
Press the PRESS button 7 to remove the mobile
♦
phone from the car cradle.
SKHU 2 B2
Press the PRESS button 7 on the rear of
the device and the fixer grips 6 of the
car cradle automatically move outwards.
GB │ IE │ NI │
13 ■