Installation; Environmental Concerns - FUST NOVAMATIC OKO 1020.2-IB Notice D'utilisation

38

INSTALLATION

Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on
the lid, you must ensure that it is made
unusable to prevent young children
being trapped inside.
Important! The appliance shall have the
plug accessible after installation.
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar), but for
optimum performance install this appliance
at a location where the ambient tempera-
ture corresponds to the climate class indi-
cated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
Rear spacers
4
Ventilation requirements
1. Put the freezer in horizontal position on
a firm surface. The cabinet must be on
all four feet.
2. Make sure that the clearance between
the appliance and rear wall is 5 cm.

ENVIRONMENTAL CONCERNS

Recycle the materials with the symbol
Put the packaging in applicable containers
to recycle it.
Help protect the environment and human
health and to recycle waste of electrical and
electronic appliances. Do not dispose
2
1
3
.
Climate Ambient temperature
class
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
3. Make sure that the clearance between
the appliance and the sides is 5 cm.
The airflow behind the appliance must be
sufficient.
appliances marked with the symbol
the household waste. Return the product to
your local recycling facility or contact your
municipal office.
with