Panasonic ER‑GY60 Mode D'emploi page 14

Removing and mounting the attachments
• Take care not to injure hands, etc., with the blade
when removing or mounting the attachment.
• All the attachments have the same method of
removing and mounting.
►
Removing the attachment
• Hold the main body
securely and pull the
attachment out upward
and remove it from the
main body.
• Hold the rib (
) part
a
securely and remove the
detail trimming
attachment and
skinguard attachment.
►
Mounting the attachment
Mount the attachment to
the main body until it
clicks.
• If the attachment is not
attached correctly, it may
shift and end up cutting
too much during use.
14
Without attachment
Trimming beard
• Use without the attachment for design precise lines.
Place the blade horizontally
against the skin and towards
the beard line trim slowly.
Trimming height: approx. 0.1 mm
(Fixed blade thickness is 0.1 mm)
a
Trimming body hair
Apply light pressure and slowly move the main
body against the direction of hair growth.
• To trim navel hair, lay the blade flat against your skin
and then move the main body in a gliding motion.
This allows you to trim hair down to a length of
approximately 0.1 mm
Click
• It does not matter which side of the blade you lay
against your skin.