Questions / Answers - koban KVD-01-33 Mode D'emploi

19. Questions / Answers

The Pole adaptor mounting stud is not seen in the case
Are you sure it's not simply still attached onto the detector?
Many users keep it attached onto their detector, even after use.
I press "Test/Arming" button, but all the Leds Stays off and
the detector looks dead!!!!
The battery may not be present or is so low that nothing is
happening. First, change the battery
I press "Test/Arming" button, The High Bright Red Leds and
the Buzzer sound intermittently, but when I release the "Test/
Arming" button, but all the Leds goes off and the detector
looks dead!!!!
The battery is low. Replace the battery with a new one.
The Detector is dirty. What can I use to clean it with, and how?
In the case, should be a full bottle of cleaning material.
kind?
The battery is situated in the front panel. Remove the 2 screws
9V battery.
The body of the Detector is scratched. Is it dangerous?
Yes, it's advised that if your detector has any trace of scratches,
you can get a replacement casing. However, this operation can
only done at the factory.
-20-
www.grupotemper.com