Safety Notes - koban KVD-01-33 Mode D'emploi

1. Safety notes

These Contact High Voltage Detectors have been designed with
safety in mind. However, no design can completely protect against
incorrect use.
Electrical circuits are dangerous and lethal through lack of
caution or poor safety practice. Follows Safety rules to reduce
danger and practice safety.
● Read the User's manual carefully and completely before using
the tester. Fully understand the instructions before using this
product. Follow the instructions for every test. Take all the
necessary precautions. Do not exceed the limits of this instrument.
● Only personnel who are fully trained in the use of High Voltage
Detectors should use this equipment. The systems that it will be
used on are powered from High Voltages which are lethal.
●
● A High voltage test is carried out with the tester attached to an
operating stick, sometime called "links stick" (or Hot Stick....etc....).
● Before use, ensure that the detector and it's accessories that are
required for use are clean, free from cracks or deep scores, and
are properly secured together.
● Always check that the detector is working Correctly before and
after the test.
● Make certain that the detector is properly rated for the Voltage of
the system under test.
● Do not touch any exposed wiring, connections or other "Live" parts
of an electrical circuit.
● Check the operation of the assembled detector complete with
accessories before and after each test.
● Do not allow a live high voltage conductor to come in contact with
the detector at a point below the limit mark.
● The detector must never be used without a handle or without
insulating rods incorporating a handle.
● Safe working distances must always be observed.
-1-
www.grupotemper.com
the