Abus Eytron JPEG2000 Dual Codec Mode D'emploi page 87

RS-232C SETUP
RS-232C SETUP
SPEED
LENGTH
STOP BIT
PARITY
SELECT MENU ▲▼, CHANGE VALUE: + -
PANTILT SETUP
PANTILT SETUP
COMMAND SETUP
SPEED SETUP
SELECT MENU ▲▼, & [ENTER]
COMMAND SETUP
COMMAND SETUP
CHANNEL
MODEL
PTZ ID
BAUDRATE
CMD DELAY
COMMAND
LENGTH
CODE
SELECT MENU ▲▼, & [ENTER]
BAUDRATE
Set here the same baud rate as set in the PTZ camera.
CMD DELAY
Set here a delay time to run the command. This value has only to be changed if problems
occur during PTZ control.
19200
8
1
NONE
01
PELCO-D
001
9600 BPS
1 MSEC
PAN LEFT
07
FF 00 01 01
00 00 00 00
This function is not used.
COMMAND SETUP
Here you can enter the settings to
communicate and control with a Pan-Tilt-
Zoom (PTZ) camera.
SPEED SETUP
Here you can adjust the movement
speed of the PTZ cameras.
CHANNEL
Select there the channel the PTZ is
connected to.
MODEL
Select here the transmission protocol.
PTZ cameras from ABUS Security-
Center use PELCO-D.
PTZ ID
Set here the same ID as set in the PTZ
camera.
87