General Operation - Clatronic CDP 604 MP3/VCD Mode D'emploi

5....-05-CDP 604 neu
Batteries in the Remote Control
The battery in the remote control is a long-life lithium cell. If the range of the remote
control decreases, please proceed as follows:
• Open the battery compartment on the side of the remote control.
• Replace the cell with a battery of the same type. Ensure the correct polarity.
• Close the battery compartment.
Mains Operation
It is possible to operate the device using the mains power unit.
1. Insert the plug of the power unit into a correctly installed 230V, 50 Hz wall
socket.
2. Connect the CD player to the power unit by inserting the plug of the power unit
into the DC 4.5 V socket (12).
3. When using a power unit (DC 4.5V/700mA) ensure the correct polarity accor-
ding to the inscriptions on the CD player.
Car Operating Mode
Thanks to the adapter cassette and the cigarette lighter adapter the CD player can
be used on your car radio with the cassette adapter.
1. Insert the cigarette lighter adapter in the cigarette lighter and the jack at the end
of the cable into the 4.5V/DC socket of the CD player.
2. Insert the jack of the adapter cassette into the AV OUT socket of the CD player.
3. Switch on your car radio and insert the adapter cassette into the cassette deck.
Make sure that the connector cable of the adapter cassette is inserted correctly
into the cassette slot! The cassette mechanism may jam!
Some car radios may eject the adapter cassette immediately after inserting it. In
this case fit the cassette's connector cable along the slot and insert the cassette
turned over on the other side. If the car radio ejects the adapter cassette again, the
adapter cassette cannot be used.
AUDIO/
EQ (6):
HOLD (9):
15.06.2004

General Operation

Switches between loudspeaker settings:
CH L, CH R, STEREO = Message in the display,
MONO L; MONO R; STEREO = Message on the screen
(only in VCD mode).
Various sound modes are available (CLASS(IC), DISCO,
JAZZ, POP).
This blocks the functions of all keys on the device and is
intended to protect against a key being activated accidental-
ly. When the switch is pushed to the right the word "HOLD"
appears in the display.
14:19 Uhr Seite 67
GB
67