Removing And Installing The Filter - Bosch DWK065G 0 Série Notice D'utilisation

Cleaning and maintenance
en
Area Cleaning agent
Controls Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Risk of electric shock caused by penetrating
moisture.
Risk of damage to the electronics from pene-
trating moisture. Never clean operating con-
trols with a wet cloth.
Do not use any stainless steel cleaners.

Removing and installing the filter

The filter must be serviced regularly in order to
guarantee efficient filtration of odours and grease.
Metal grease filter
The metal grease filters must be cleaned every 150
operating hours or at least every three months.
:
Warning – Risk of fire!
Fatty deposits in the grease filter may catch fire.
Clean the grease filter at least every 3 months.
Never operate the appliance without a grease filter.
Activated charcoal filter (only in circulating-air mode)
The activated charcoal filters must be changed at least
every 3 to 5 months.
Removing metal grease filter
The metal grease filters filter the grease out of kitchen
steam. To keep them in good working order, the filters
should be cleaned at least every 3 months.
Open the lock on the metal grease filters and
1.
remove the filters from the retainer.
Notes
– When you do this, take hold of the metal grease
filters from underneath with your other hand.Make
sure that the metal grease filters do not fall and
damage the hob.
– Fat may accumulate in the bottom of the metal
grease filters. Hold the filters level to prevent fat
from dripping out.
Clean the metal grease filters.
2.
Clean the inside of the appliance.
3.
Changing the activated charcoal filter
(only in circulating-air mode)
To ensure effective odour removal, the filters must be
serviced regularly.
The activated charcoal filters must be replaced at least
every 3 to 5 months.
8
Notes
The activated charcoal filters are not included with
■
the appliance. Activated charcoal filters are available
from specialist retailers, from our after-sales service
or from our online shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
Remove the metal grease filter; see above.
1.
Turn the old activated charcoal filters and pull them
2.
from the holder. ¨
Push the new activated charcoal filters onto the
3.
holder and turn. ©
Cleaning the metal mesh grease filters
Notes
Do not use any aggressive, acidic or alkaline
■
cleaning agents.
When cleaning the metal mesh grease filters, also
■
clean the holder for the metal mesh grease filters in
the appliance using a damp cloth.
The metal mesh grease filters can be cleaned in the
■
dishwasher or by hand.
By hand:
You can use a special grease solvent for
Note:
stubborn dirt. It can be ordered via the Online Shop.
Soak the metal mesh grease filters in a hot soapy
■
solution.
Clean the filters with a brush and then rinse them
■
thoroughly.
Leave the metal mesh grease filters to drain.
■
In the dishwasher:
If the metal mesh grease filters are cleaned in the
Note:
dishwasher, slight discolouration may occur. This has
no effect on the function of the metal mesh grease
filters.
Do not clean heavily soiled metal mesh grease filters
■
together with utensils.
Place the metal mesh grease filters loosely in the
■
dishwasher. The metal mesh grease filters must not
be wedged in.
Installing the metal grease filter
With the lock facing the front, insert the metal grease
filter into the underside of the appliance and engage the
lock.
When pushing the filter in, make sure the lock
Note:
engages. Otherwise, the metal grease filter may fall and
damage the hob.