Software Installation - Spinlock XX Clutch XX0812 Mode D'emploi

ZS-LCW Software Instructions

Software Installation

Insert the CD into your drive. If the disc does not auto run browse to your CD drive and open the
with installation either contact spt@spinlock.co.uk
Check on www.spinlock.co.uk for software updates.
You will need administrator rights over your computer to install this software.
Set Up
Initially have the rope sense unit close to your PC. Plug the USB aerial into a spare USB socket on
associated with the load cell. Do this by pressing the 'Settings' button and entering the 6 digit
menu under 'Select Log Directory'
now ready for use.
Operation
software and start again).
spread sheet tools to process and analyse the data.
possible on the hardware (other than removing the batteries).
46
www.spinlock.co.uk
spinlock_hi_load_A5_12_1.indd 46-47
or your computer administrator.
'Remote Address' box. Press 'OK' on the
'Settings'
'Log Data' button and
Operation
The program can be adjusted to suit your requirements. Press the 'Settings' button to access these.
Below is a list of adjustable settings:
Decimal Display
Fast Transmit Delay
Load Units
Graph Top
Graph Bottom
Select Log Directory
Time Stamp Logged Data
Show Graph
Warning: Your computer must be set to use a decimal place '.' rather than a ','. If not the
read out will be erratic. This can be found in the regional options control panel.
Contact spt@spinlock.co.uk if you require assistance with any feature of
Spinlock Rope Sense.
47
23/11/12 10:24:31