General Maintenance - Spinlock XX Clutch XX0812 Mode D'emploi

XXC0812, XXC0812/L, XX0812, XX0812/L Clutch

General maintenance:

Three Simple Steps – flush, drain and lubricate
1. The internal mechanism should be regularly flushed out with fresh water through the end
bullseyes, and the handle pivot area.
2.
help reduce the accumulation of any rope debris building up inside the product.
3.
regularly, the specified performance will not be achieved. Take care not to contaminate rollers
or jaw surfaces with any lubricant.
Note :
Any decrease in performance is usually caused by lack of maintenance and servicing. The
XXC0812 and XX0812 relies on the smooth running of 2 sets of roller bearings for maximum
Removal from deck
If removing the XX0812 from the deck, care must be taken to ensure the fasteners do not damage
the internal mechanism and plastic rear moulding. Do not hammer fasteners from below.
Watch the XX Servicing Video at
24
www.spinlock.co.uk
spinlock_hi_load_A5_12_1.indd 24-25
www.spinlock.co.uk
XXC0812, XXC0812/L, XX0812, XX0812/L Clutch
Full servicing and Jaw Replacement:
The clutch should be given a thorough service periodically to ensure maximum performance is
If upgrading jaws from a Pre 2010 XX0812, then part XX-KIT is required. See www.spinlock.
co.uk for full upgrade instructions, including video from the Pre 2010 Model.
1. Remove the rope from the clutch.
2.
3.
moulding. Remove this screw.
4. Hold rear cover at top and rotate and pull out from the top.
5. Pull the complete rear moulding and jaw assembly free from the body.
how to use
XX0812
pages 14-15
installation spares
25
pages 20-21 pages 36-37
23/11/12 10:24:16