Handle Assembly Replacement Xx-Hdlb - Spinlock XX Clutch XX0812 Mode D'emploi

Handle Assembly Replacement XX-HDLB

1. Remove the rope from the clutch.
2.
3.
moulding. Remove this screw.
4. Hold rear cover at top, rotate and pull out from the top.
5. Pull the complete rear moulding and jaw assembly free from the body
6.
7. Slide out the handle assembly through the rear of the body.
8. Thoroughly clean with fresh water and inspect the following critical items:
Roller Cages (both are identical) - unclip from jaw and look for signs of wear or flats on the
roller surfaces. If flats are found replace & consider upgrade to XX-ROLL+
Jaw Bearing Surfaces - ensure that both are clean and smooth.
Jaw Grip Surfaces - clean off any rope debris. Check for excessive wear on the grip surface. If
the black anodised surface has aluminium showing through, replace with a new
XX-JAW or XXC-JAW assembly.
Jaw Linkplates - check these are attached to both sides of both jaws with pins and secured
Release Pin - located centrally in top jaw. Check for any signs of surface wear.
Clutch Body - flush clean inside, paying particular attention to the upper and lower roller
surfaces, the two drainage runs in the base and their exits at the end mouldings.
28
www.spinlock.co.uk
spinlock_hi_load_A5_12_1.indd 28-29
Re-assembly
1.
2.
3.
4. Insert jaw assembly in body of XX.
5. Angle rear moulding backward, to locate lower fixing hooks in body.
6. Rotate top of cover into place flush with XX body.
7.
8.
opening and closing the handle fully.
9. For standard versions, open and close the handle fully to ensure fully operational.
10.
how to use
XX0812
pages 14-15
installation spares
29
pages 20-21 pages 36-37
23/11/12 10:24:18