Handle Assembly Replacement Xxc-Hdlb - Spinlock XX Clutch XX0812 Mode D'emploi

Handle Assembly Replacement XXC-HDLB

1. Remove the rope from the clutch.
2.
3.
moulding. Remove this screw.
4. Hold rear cover at top, rotate and pull out from the top.
5. Pull the complete rear moulding and jaw assembly free from the body
6.
1
7. Punch the 2 locating pins through the body (see diagram 1). Note: these have been locktite in
place. For the side mounted versions screw in a M4 fastener into the pin to lift and remove
(see diagram 2).
8. Slide out the handle assembly through the rear of the body.
9. Thoroughly clean with fresh water and inspect the following critical items:
Roller Cages (both are identical) - unclip from jaw and look for signs of wear or flats on
the roller surfaces. If flats are found replace XX-ROLL+
correct orientation.
30
www.spinlock.co.uk
spinlock_hi_load_A5_12_1.indd 30-31
2
Jaw Bearing Surfaces - ensure that both are clean and smooth.
Jaw Grip Surfaces - clean off any rope debris. Check for excessive wear on the grip surface. If
the black anodised surface has aluminium showing through, replace with a new
XXC-JAW Assembly.
Jaw Linkplates - check these are attached to both sides of both jaws with pins and secured
Release Pin - located centrally in top jaw. Check for any signs of surface wear.
Clutch Body - flush clean inside, paying particular attention to the upper and lower roller
surfaces, the two drainage runs in the base and their exits at the end mouldings.
Re-assembly
1.
2.
3.
4. Insert jaw assembly in body of XXC.
5. Angle rear moulding backward, to locate lower fixing hooks in body.
6. Rotate top of cover into place flush with XXC body.
7.
8.
opening and closing the handle fully.
9. For standard versions, open and close the handle fully to ensure fully operational.
10.
how to use
XXC0812
pages 14-15
installation spares
31
pages 20-21 pages 36-37
23/11/12 10:24:19