Saving, Retrieving And Deleting Results; Error Messages/Troubleshooting - Sanitas SBM 19 Mode D'emploi

Range of blood pressure values
Grade 3: Severe hypertension
Grade 2: Moderate hypertension 160-179
Grade 1: Mild hypertension
High-normal
Normal
Optimal
Source: WHO, 1999
The bar graph in the display and the scale on the unit
indicate the range of the blood pressure which has been
recorded. An accoustic evaluation of your measurement
also follows.
If the values for systolic and diastolic pressure are in two
different WHO ranges (e.g. systolic in the high-normal
range and diastolic pressure in the normal range) the gra-
phic WHO classification on the unit indicates the higher
range (high-normal in the example described).

6. Saving, retrieving and deleting results

• The results of each successful measurement are stored
together with date and time. With more than 60 items of
measured data, the earliest items of data measured are
lost.
• In order to retrieve measurement results again, press the
memory button ‚MEM'. The instrument first displays the
number of memory spaces occupied and then automati-
cally switches to the last saved test result. All the stored
measured values are also acoustically output.
Systolic Diastolic
(in mmHg) (in mmHg)
>=180 >=110
100-109
140-159 90-99
130-139 85-89
120-129 80-84
<120 <80
15
Measure
Seek medical advice
Seek medical advice
Have it checked regularly by doctor
Have it checked regularly by doctor
Check it yourself
Check it yourself
• Pressing the memory button ‚MEM' again outputs the
further measurement values with date and time.
• You can clear the memory by holding down the memory
button ‚MEM' for 3 seconds.

7. Error messages/troubleshooting

In case of faults, the ‚EE' message appears in the display.
Error messages can occur when
1. inflation pressure is higher than 300 mmHg,
2. blood pressure is unusually high or low,
3. you move or talk during the measurement,
4. the cuff tube is not inserted properly,
5. the cuff is inflated for longer than 30 seconds.
In the above cases, you must repeat the measure ment.
Make sure that the cuff tube is properly inserted and that
you do not move or talk. Re-insert the batteries if neces-
sary, or else replace them.