Important - Bio Green MONTANA Mode D'emploi

IMPORTANT:

Carefully read and follow these operating instructions and the general safety instructions.
Store this document carefully for future reference. If you are in doubt concerning the safety
of the device, consult a trained technician. When operating in a greenhouse, make sure
that the electrical connections are installed by a qualified technician.
1. General information
When unpacking the device, and prior to use, make sure the device and all related
accessories are free of defects and in good working order. In case of damage caused
during transport, immediately consult the relevant distributor or manufacturer. The packing
materials (plastic bags, polystyrene) represent a potential safety hazard and must be kept
out of reach of children.
The MONTANA electronic fan heater is used for heating green houses and winter gardens.
It is easy to operate. This device is only authorized for connection to 230V, 50/60 Hz AC
voltage. It must be protected from soiling and moisture. Use of the device for other
purposes can result in damage to the device and other hazards, such as short circuits, fire,
and electrical shocks, etc. Safety and installation instructions must be followed at all times.
When using a power strip or extension cord, care must be taken to ensure that the
maximum load capacity is not exceeded. Cable reels must be completely unreeled at all
times.
2. Technical data
Device type:
Supply voltage
Output:
Power input:
Control range:
Protection class:
9
MONTANA
230 V, 50/60 Hz
1000 / 2000 W
9.5 A (max.)
5 – 85 ° C
II
EN