Tools Needed For The Assembly; Your 3 Channel Radio System - Carson Stormracer Extreme 103013 RTR Mode D'emploi

Tools needed for the assembly

GB
Modelling knife 74053
Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm 74023

Your 3 channel radio system

Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the centre
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Receiver antenna
Engine
throttle
servo
6 CARSON Stormracer extreme 103013 RTR und 102001 ARR
011599_anl_stormracer_6k.indd 6
Instant adhesive 53339
Hexagonal wrench 13118
Batteries for receiver
Switch
Steering servo
Needle nose pliers 74034
Tweezers 74003
(only for RTR version)
Transmitter
Scissors 13305
Side cutter 74035
04.12.2007 11:28:29 Uhr