Pressure Washer Maintenance - Briggs & Stratton 1950 PSI Manuel D'utilisation

SPECIFICATIONS
Outlet Pressure . . . . . . . . . . . . . . . . . 135 bar (1950 psi)
Flow Rate . . . . . . . . . . . . . . . . 7.5 litres/minute (2.0 gpm)
Detergent Use detergent approved for pressure washers
Water Supply . . . . . . . . . Not to Exceed 37.7ºC (100°F)
Temperature
Automatic Cool . . . . . . . . . . . . . . Will cycle when water
Down System
Measured LwA . . . . . . . . . . . . . . . . . . . . . .100 dB(A)/pW
Guaranteed LwA . . . . . . . . . . . . . . . . . . .100 dB(A)/pW
Sound Pressure Level @ 7m . . . . . . . . . . . . . .75 dB(A)
Shipping Weight . . . . . . . . . . . . . . . . . . . . .21 kg (46 lbs.)
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
NOTE: Should you have questions about replacing
components on your BSPP pressure washer, please visit
our website at www.briggsandstratton.com.
• Some adjustments will need to be made periodically to
properly maintain your pressure washer.
• All maintenance in this manual and the engine owner's
manual should be made at least once each season.
• Once a year you should check the spray gun and adjustable
nozzle extension assembly for wear.Also clean or replace
the spark plug and clean or replace the engine air filter.
Please refer to engine owner's manual for more details.
Before Each Use
1. Check engine oil level.
2. Check water inlet screen for damage.
3. Check in-line filter for damage.
4. Check high pressure hose for leaks.
5. Check chemical injection hose and filter for damage.
6. Check spray gun and adjustable nozzle extension
assembly for leaks.
7. Rinse out garden hose to flush out debris.
BSPP 1950 PSI Pressure Washer
reaches 51-68°C (125°-155°F)
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER repair high pressure hose. Replace it.
• Replacement hose rating MUST exceed maximum pressure
rating of unit.
Check Chemical Injection Hose
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Check Gun and Adjustable Nozzle
Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the safety latch in the ON position and test the trigger.You
should not be able to press the trigger.
12