Turning The Burner Off - AEG HG995440XB Notice D'utilisation

www.aeg.com
8
If the burner does not light after
some tries, check if the crown
and its cap are in correct posi-
tions.
Each control knob has a pilot
light. It lights up when you turn
the control knob.
A) Burner cap and crown
B) Thermocouple
Ignition candle
C)
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without
A
electrical device; in this case ap-
proach the burner with a flame,
push the relevant knob down
and turn it counter-clockwise to
maximum gas release position.
If the burner accidentally goes
B
out, turn the control knob to the
off position and try to light the
burner again after minimum 1 mi-
nute.
C
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.

4.2 Turning the burner off

A
To put the flame out, turn the knob to
the symbol
WARNING!
B
Always turn the flame down or
switch it off before you remove
the pans from the burner.
C
D
.