DeWalt XR LI-ION DCB115 Manuel page 45

the rating plate. Also make sure that the voltage of your charger
corresponds to that of your mains.
Your D WALT charger is double insulated in accordance with
e
EN60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the D
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the earth
terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary.
Use an approved extension cable suitable for the power input of your
charger (see Technical Data). The minimum conductor size is 1 mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
MAINTENANCE
Your D WALT power tool has been designed to operate over a long
e
period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
WALT service organisation.
e
ENGLI SH
;
2
43