Rega plus Mode D'emploi page 3

THE ON/OFF SWITCH IS LOCATED
UNDERNEATH THE PLINTH
A
331/3 rpm
45 rpm
A B
LOCATED BENEATH THE
PLATTER
B
C
SETTING UP YOUR PLANAR 1 PLUS
Carefully unpack the turntable, always keeping it upright. • Check the
belt is fitted around the drive pulley (A) and sub-platter (B). • Remove
the packing card (C) from beneath the sub-platter (B) and fit the platter
(1) and mat. • Push the balance weight (4) fully onto the rear of the
tonearm (3) until it reaches the stop point as shown (D). • Connect the
phono output to an appropriate line level input (see page 2). • Connect
the power supply to the rear of the turntable (see page 2). • Carefully
remove the stylus guard from the cartridge (2). • Turn on the Planar 1
Plus via the on/off switch located on the underside of the plinth (5). •
Change the speed by moving the drive belt from the 331/3 and 45 steps
of the pulley (A). • The RB110 tonearm (3) is preset for bias adjustment,
no other set-up is required.
v4
C
A D
www.rega.co.uk
EN
1
D
MADE IN ENGLAND