Safety Instruction - Hikmicro HM-TP31-3AUF-E1L Guide De Démarrage Rapide

Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (B)/NMB-3(B) standards requirements.

Safety Instruction

These instructions are intended to ensure that user can use the product correctly to avoid danger or property
loss.
Laws and Regulations
● Use of the product must be in strict compliance with the local electrical safety regulations.
Transportation
● Keep the device in original or similar packaging while transporting it.
● Keep all wrappers after unpacking them for future use. In case of any failure occurred, you need to return the
device to the factory with the original wrapper. Transportation without the original wrapper may result in
damage on the device and the company shall not take any responsibilities.
● Do not drop the product or subject it to physical shock. Keep the device away from magnetic interference.
Power Supply
● The input voltage should meet the Limited Power Source (5 VDC, 300 mA) according to the IEC61010-1
standard. Please refer to technical specifications for detailed information.
● Make sure the plug is properly connected to the power socket.
● DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards caused by
overload.
Battery
● The built-in battery cannot be dismantled. Please contact the manufacture for repair if necessary. The battery
may explode if it is replaced by an incorrect type. Replace with the same or equivalent type only. Dispose of
used batteries in conformance with the instructions provided by the battery manufacturer.
● For long-term storage of the battery, make sure it is fully charged every half year to ensure the battery quality.
Otherwise, damage may occur.
● Make sure the plug is properly connected to the power socket.
● The standard adapter power supply is 5 V.
● The battery is certified by UL2054.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by unauthorized repair or maintenance.
● Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
device may be impaired.
Using Environment
● Make sure the running environment meets the requirement of the device. The operating temperature shall
be -10°C to 50°C (14°F to 122°F), humidity shall be 90% or less, and height ≤5000 m.
● Place the device in a dry and well-ventilated environment.
● DO NOT expose the device to high electromagnetic radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright light.
● When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it
may burn out.
● The device is suitable for indoor and outdoor uses, but do not expose it in wet conditions.
● The level of protection is IP 54.
4