dB Technologies READY 4 Mk2 Mode D'emploi page 39

7. Move the HT-READY 4 or BT-READY 4 close to the IR LED; the ideal distance between the devices
is of about 20-30 cm.
8. The POWER LED on the HT-READY 4 or BT-READY 4 transmitter blinks briefly to indicate the
synchronisation is completed. After a few seconds the wireless configuration page of READY-4
MK2 displays the confirmation that connection has been established on the selected channel.
9. You can now use wireless communication for a microphone of the selected type. If using HT-
READY 4, put the cover back into place, to close the microphone.
10. The settings you made shall be retained even after you switch off the READY 4 MK2, and
therefore will still be in effect at switch-on. To change the channel to be used, repeat the
procedure.
ENGLISH
38