How.to.connect - Friedrich PTAC PDE07K Mode D'emploi

How To Connect
IMPORTANT: Please read following electrical safety data carefully.
WARNING
Electrical Shock and/or Unit
Operation and Damage Hazard
Failure to follow this warning could result in
personal injury or death and/or unit damage.
Follow the National Electrical Code (NEC)
or local codes and ordinances.
For personal safety, this unit MUST BE
properly grounded.
Protective devices (fuses or circuit breakers)
acceptable for unit installations are specified
on the nameplate of each unit.
Do not use an extension cord with this unit.
Aluminum wiring in the building may present
special problems - consult a qualified
electrician.
When unit is in STOP position, there is
still voltage to the electrical controls.
Disconnect power to unit before servicing by:
1. Removing power cord (if it has one) from
wall receptacle.
2. Removing branch circuit fuses or turning
circuit breakers off at panel.
1. Remove.front.panel..See.Figure.22.
2. Remove.junction.box.
Remove.junction.box.cover.by.removing.three.screws.from.
•
front..Remove.junction.box.by.taking.out.top,.rear.and.side.
screws..See.Figure.25.
Figure 25
Junction Box Location
JUNCTION BOX COVER
UNIT
CONNECTOR
JUNCTION BOX
FRP017
3. Connect.accessory.power.supply.cord.or.hard.wire.connector.to.
unit.connector..See.Figure.26.
Units.must.be.installed.using.the.appropriate.power.supply..
•
kit..See.Table.2.--POWER.CONNECTION.CHART..These.
connections.must.be.followed.
Figure 26
Power Connection
See.Table.2.on.page.14.for.power.cord.accessory.options.and.ratings.
4. Reinstall.junction.box.and.cover.
Use.wire.clamp.to.attach.power.cord.to.basepan..Secure.
•
with.screws.(included).See.Figure.27.
Replace.junction.box.and.cover.with.screws.removed.from.
•
Step.2..Tighten.securely.
5. Replace.front.panel..See.Figure.24.
6. Connect.power.to.unit.
Figure 27
Wire Clamp
ACCESSORY
POWER SUPPLY CORD
OR HARD WIRE
FRP018
WIRE CLAMP
FRP019
19