Assembling The Appliance; Vacuum-Cleaning - Bosch Unlimited BCS1 Serie Mode D'emploi

8001 108 997 - 980320
Charging with a charging cable only
2
Fig.
•
To charge the vacuum cleaner, place it near to a so-
cket.
•
Plug the charging cable into the connection point at
the bottom of the appliance.
•
Plug the charging cable plug into the socket.
•
The vacuum cleaner's indicator light will slowly lash
green as it charges.
Once the battery is fully charged, the indicator light
will remain continuously lit for a few minutes before
going out.
Disconnect the appliance from the mains briely to
check it. The indicator will then light up green again.
•
It is normal for the charging cable and vacuum clea-
ner to heat up and this is not a cause for concern.
•
You can charge the vacuum cleaner whenever it is
not in use.
Fitting the docking station
3
Fig.
•
Fit the docking station close to a socket.
•
To do this, remove the front plate from the docking
station. Insert your inger into the docking station
from below, and push the front plate from the inside
and out of the locking mechanism. Use the screws
provided (or equivalent screws) to mount the do-
cking station on the wall.
•
Insert the small connector on the charging cable into
the docking station from below, and then up and into
the preformed recess.
•
Put the front plate back on and lock it in place to
secure the connection in place.
•
Plug the charging cable's mains plug into the socket.
Charging in the docking station
4
Fig.
•
Place the vacuum cleaner into the docking station
from above.
•
The vacuum cleaner's indicator light will start to
lash slowly once the vacuum cleaner is connected
to the mains power supply via the docking station.
•
The vacuum cleaner's indicator light will lash green
as it charges.
Once the battery is fully charged, the indicator light
will remain continuously lit for a few minutes before
going out.
Disconnect the appliance from the mains briely to
check it. The indicator will then light up green again.
•
It is normal for the charging cable and vacuum clea-
ner to heat up and this is not a cause for concern.
•
You can charge the vacuum cleaner whenever it is
not in use.
46
Charging using the quick charger*
•
To use the quick charger for charging, the battery
must be removed from the appliance (
•
Please see the user manual provided for more infor-
mation on how the quick charger works.
Charge time
The charge time stated here may vary due to charge
status, battery temperature and battery age.
Via charging cable or do-
cking station (80%)
Via charging cable or do-
cking station (100%)
Via Bosch quick charger

Assembling the appliance

5
Fig.
•
Fit the end of the suction tube onto the vacuum
cleaner's connection port and lock it in place.
•
To release the suction tube, press the release button
and pull the suction tube down to remove it
6
Fig.
•
Insert the end of the suction tube into the loor nozz-
le and lock it into place.
•
To release the loor nozzle, press the release button
and pull the suction tube out of the loor nozzle.

Vacuum-cleaning

7
Fig.
The vacuum cleaner can be switched on and off by
pushing the On/Off switch on the handle in the direc-
tion of the arrow. When the vacuum cleaner is switched
on, the indicator light will be lit green.
8
Fig.
When the appliance is running the turbo function can
be activated by pushing the turbo switch on the vacu-
um cleaner in the direction of the arrow. The indicator
light will lash green rapidly.
* Depending on model
1
)
Fig.
For one 3,0Ah Bosch
Power for ALL battery
approx. 4 h
approx. 5 h
Reference to quick char-
ger manual