Christopeit Sport AB 1 Notice De Montage Et D'utilisation page 16

Step 3:
Installation of saddle (24) at saddle support (30) by using saddle slide
(25).
1. Push the saddle (24) with saddle bracket into the movable saddle slide
(25) and tight it up in desired position.
2. Place the movable seat post (25) into the holder of saddle post (30), set
it at the desired horizontally position and tighten it by washer (28) and
movable seat knob (29).
Step 4:
Installation of the saddle support (30) on the main frame (23) with the
rapid-action lock (32).
1. Insert the saddle support (30) into the provided holder of the main frame
(23) and secure at the desired position by screwing in the rapid-action
lock (32).
(Note: To screw in the rapid-action lock (32), the threaded hole in the
main frame (23) and one of the holes in the saddle support (30) must be
aligned. Furthermore, ensure that the saddle support (30) is not pulled
out of the main frame beyond the marked maximum Position. The setting
of the saddle post can be adjusted as desired later. For this, the rapid
action catch (32) must be loosened by only a few revolutions, the cap
of the lock must be pulled away and the saddle adjusted. Then secure
the new setting by tightening the rapid action catch.
Step 5:
Installation of the handlebar (14) and computer (1) on the handlebar
support (11).
1. Place the handlebar (14) against the handlebar support (11) and adjust
so that the hole patterns in the handlebar and the handlebar support are
aligned. Put one spring washer (76) on each screw (9). Push the screws
(9) through the holes in the support, screw into the threaded holes of
the support (11) and tighten fi rmly.
2. Cover the handle bar connection with handlebar cover (5).
3. Take the computer (1) that has been supplied out of the packaging and
insert the batteries (Type "AAA"-1.5 V pencells) by watching for the right
polarity on the back of the computer (1). (Batteries for the computer
are not included in this item. Please buy them at your located market.)
Push the plug of the connecting cable (2) projecting from the handlebar
support (11) into the associated socket of the computer (1).
4. Attach the monitor (1) to top monitor bracket of front post (11) with
screws (84) and washer (49).
5. Push the plug of the pulse cable (16) projecting from the handlebar (14
into the associated socket of the computer (1).
16