S+S Regeltechnik KYMASGARD GW1-RS485-FEM Mode D'emploi page 19

G
Commissioning
The first steps to enable quick commissioning by using our parameterization software X485 are listed below.
Initial situation: Parameterization software is installed on a PC ⁄ laptop and a RS 485 network exists.
The baud rate settings at the master and at the gateways are set to the same value.
1. Connect the first gateway to the RS 485 bus and apply voltage.
Make sure no other gateway having the same subscriber ID number (TLNR) is connected at that moment.
Die LED L1 must be on.
2. Set basis ID in "Register 1"
Default address is FFFFFF80h plus the correct COM address.
3. First communication test using parameterization software
Try to change the status of LED L5 using the buttons "Signal_On", "Signal_OFF" and "Signal_Flash".
If that is possible, correct communication exists.
Activate radio transmitters. The telegrams must show up displayed under the register "Test" of the parameterization software.
4. Learning of a radio transmitter
Press button S3 long enough till LED L3 is flashing. Release button S3, the gateway goes to learning mode und you just have deleted the input
filter completely.
Now learn radio transmitters. Each new transmitter ID learned is indicated by a short "off" flash of LED L3 and by a corresponding telegram
from the master. After all sensors are learned, you can switch back to normal operating mode by pressing button S3 for two seconds. LED L3
goes off.
5. Subscriber ID number is changing. The station is now ready for operation.
G
Important notes
According to the German Battery Ordinance, each consumer is legally bound to return all used and/or consumed batteries and recharge-
able batteries. Disposal via household garbage is prohibited. Old batteries (regular as well as rechargeable batteries) can be disposed at
public collection points free of charge.
Our "General Terms and Conditions for Business" together with the "General Conditions for the Supply of Products and Services
of the Electrical and Electronics Industry" (ZVEI conditions) including supplementary clause "Extended Retention of Title" apply as
the exclusive terms and conditions.
In additionIn addition, the following points are to be observed:
– These instructions must be read before installation and putting in operation and all notes provided therein are to be regarded!
– This device shall only be used for its intended purpose. Respective safety regulations issued by the VDE, the states, their control
authorities, the TÜV and the local energy supply company must be observed. The purchaser has to adhere to the building and safety
regulations and has to prevent perils of any kind.
– No warranties or liabilities will be assumed for defects and damages arising from improper use of this device.
– Consequential damages caused by a fault in this device are excluded from warranty or liability.
– These devices must be installed by authorised specialists only.
– The technical data and connecting conditions of the mounting and operating instructions delivered together with the device are
exclusively valid. Deviations from the catalogue representation are not explicitly mentioned and are possible in terms of technical
progress and continuous improvement of our products.
– In case of any modifications made by the user, all warranty claims are forfeited.
– This device must not be installed close to heat sources (e.g. radiators) or be exposed to their heat flow. Direct sun irradiation or
heat irradiation by similar sources (powerful lamps, halogen spotlights) must absolutely be avoided.
– Operating this device close to other devices that do not comply with EMC directives may influence functionality.
– This device must not be used for monitoring applications, which solely serve the purpose of protecting persons against hazards or
injury, or as an EMERGENCY STOP switch for systems or machinery, or for any other similar safety-relevant purposes.
– Dimensions of enclosures or enclosure accessories may show slight tolerances on the specifications provided in these instructions.
– Modifications of these records are not permitted.
– In case of a complaint, only complete devices returned in original packing will be accepted.
These instructions must be read before installation and putting in operation and all notes provided therein are to be regarded!
19