Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Slide the nails toward the rear of the magazine. The
nails stop at the entrance of the magazine because of
the nail stopper. Unlock the magazine by pressing the
button of the nail stopper to remove the nails.
Changing the magazine (optional
accessory)
► 1. Bolt
A magazine with different length is available as optional
accessory.
To change the magazine, loosen the bolt and remove
the magazine. Then install the new magazine. And
fasten the bolt on the magazine.
OPERATION
WARNING:
•
Do not touch around the exhaust vent. The
surface will be very hot during or after an oper-
ation. Touching around the exhaust vent may
cause burns or injuries.
CAUTION:
•
Make sure all safety systems are in working
order before operation.
1.
To drive a nail, place the contact element against
the workpiece.
The fan motor is activated, fuel gas is injected into com-
bustion chamber and mixed with air by the fan.
1
1
► 1. Trigger
2.
Hold the contact element pressing firmly and pull
the trigger.
Fuel gas is combusted and the nail is driven.
3.
Further driving can be initiated only after both the
contact element and the trigger are released.
Nail-driving of concrete
WARNING:
•
Use hardened nails only for concrete.
Using other purposed nails may cause serious
injuries. Do not nail directly on the concrete.
Failure to do so may cause concrete fragments
to fly off or nails to strike back, causing serious
injuries.
•
When driving nails, hold the tool so that it stands
upright to the driving surface.
Slanted nail-driving may cause concrete frag-
ments to fly off or nails to strike back, causing
serious injuries.
•
Do not use the tool on the surface that objects
hang from, such as area where hangers for
sewer pipe, dust pipe etc. are set up
Choose and use appropriate nails so that the penetra-
tion amount into concrete ranges 15 mm (9/16") - 20
mm (13/16").
9 ENGLISH
Publicité
Table des Matières
