How To Hang Your Ceiling Fan - Emerson HF1160BQ02 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BP7272-4 HF1160.qxp_BP7272 9/10/15 9:44 PM Page 9

4. How to Hang Your Ceiling Fan

4.2
Screw the eye screw (supplied) into the joist
7 inches from the center of the ceiling outlet box
(Figure 12).
Read and follow instructions carefully. Failure to comply
with instructions could result in risk of fire, electric
shock, fan falling and injury to persons.
4.3
Carefully lift the fan and seat the hanger ball/
downrod assembly into the hanger bracket that was just
attached to the outlet box (Figure 13).
Be sure the groove in the ball is lined up with anti-rotation
tab on the hanger bracket (Figure 13).
4.4
This fan is equipped with the required retention cable.
This cable must be affixed to the building structure and
securely clamped in such a manner to support the weight of
the fan in the event the mounting hook or other parts fail.
Pass the end of the safety cable through the two cable
clamps (supplied) (Figure 14). Pass the end of the safety
cable through the eye screw and then back through the two
NOTE: Leave approximately 3" but no more than 5" of
cable clamps.
slack on this safety cable to allow for possible fan
movement. Do not exceed more than 5" total slack.
After verifying that the cable clamps are positioned properly
on the safety cable, tighten the nuts on the
U-bolts.
WARNING
!
(Continued)
EYE SCREW
7"
Figure 12
NOTE: CEILING COVER, SUPPL Y WIRES AND FAN WIRES
OMITTED FOR CLARITY.
Figure 13
Figure 14
EYE SCREW
CAUTION: It is important to note the proper
installation position of the cable clamps as illustrated
in Figure 14. To obtain maximum holding power,
install U-bolt section of clip on dead or short end of
cable and saddle on long end of cable. Improper
installation reduces the efficiency of the connection by
as much as 40 percent.
Please contact 1-800-654-3545 for further assistance
9
OUTLET BOX
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
HANGER BALL
HANGER
BRACKET
HANGER BALL
GROOVE
ANTI-ROTATION TAB
TO FAN
CABLE CLAMP
emersonfans.com
U.L. Model No.: HF1160-2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hf1160bs02Hf1160ww02

Table des Matières