Emerson HF1160BQ02 Mode D'emploi page 17

BP7272-4 HF1160.qxp_BP7272 9/10/15 9:44 PM Page 17
6.13
SW95 Single Fan Wall Control Wiring (Figure 31).
TO NEUTRAL
Figure 31
6.14
After completing installation, test run fan in normal
operation manner. Inspect for any possible shake or
wobble which may be caused by binding as a result of
"tight cable". if this should happen, shut off power supply
and re-check instructions to correct problem.
6. Wall Control Installation
TO FAN MOTOR LOAD
(Continued)
BLACK
BLACK
GREEN
SW95 SINGLE FAN
WALL CONTROL
NOTE: When any solid state motor speed control is
used, a humming noise may be present in the fan on
low speed. This hum in no way affects the operation
of the fan and is acceptable in most installations.
Please contact 1-800-654-3545 for further assistance
17
BLACK or RED
BLACK
GREEN
TO 120VAC
SOURCE HOT
emersonfans.com
U.L. Model No.: HF1160-2