Charging; Operation; Changing The Comb Attachments; Changing The Thinning Out Attachment - SilverCrest SHBS 600 A1 Mode D'emploi

BB*5$B%ERRN 6HLWH  'LHQVWDJ  1RYHPEHU    

5. Charging

NOTES:
• Before first use (without cable), and for
every charging procedure afterwards,
charge the hair and beard trimmer|4 for
a maximum of 90 minutes.
• When the battery is fully charged, the
device can be used for approximately
60 minutes without being connected to
the power supply.
• When the batteries are nearly empty,
the plug symbol
play|7. The device can then only be
used for a short time (approx. 7|min-
utes) without being connected to the
electricity supply.
1. Swivel the locking bar at the bottom of
the battery charger|9 in clockwise di-
rection out of the locking position.
2. Figure A: plug the right angle connec-
tor of the power unit into the bottom of
the battery charger. Lock the connector
by swivelling the locking bar in anti-
clockwise direction until it stops.
3. Lay the power unit cable into the cable
guide of the battery charger|9 and
place it onto a plane surface.
4. Switch off the device with the on/off
switch |6 if necessary.
5. Insert the power unit|8 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
6. Put the hair and beard trimmer|4 into
the battery charger|9.
7. The charging indicator
play|7 flashes and the battery is
charged. If the battery is fully charged
the charging indicator
stantly and 60 MIN is shown on the
display.

6. Operation

Regardless of the charging state of the bat-
tery, the hair and beard trimmer can always
be mains-operated.
1. For mains operation, ensure that the
2. Connect the power unit|8 to the con-
3. Insert the power unit|8 into a readily
flashes in the dis-
4. Switch on the device with the on/off
6.1 Changing the comb
• Figure B: to attach the comb attach-
• Figure C: to remove the comb attach-
6.2 Changing the thinning
• Figure D: to attach the thinning out at-
on the dis-
glows con-
• Figure C: to remove the thinning out at-
hair and beard trimmer|4 is switched
off.
nector of the hair and beard trimmer|4.
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
switch |6.
attachments
ments|1 carefully push the appropriate
comb attachment onto the trimmer at-
tachment|3. Let both pins of the comb
attachment|1 engage properly into the
lateral grooves of the hair and beard
trimmer|4.
ments|1 slide the laterally engaged pins
out of the grooves of the hair and beard
trimmer|4 and pull off the comb attach-
ment.
out attachment
tachment|2 carefully push it onto the
trimmer attachment|3. Let both pins of
the thinning out attachment|2 engage
properly into the lateral grooves of the
hair and beard trimmer|4.
tachment|2 slide the laterally engaged
pins out of the grooves of the hair and
beard trimmer|4 and pull it off.
7
GB