Items Supplied; Charging; Operation; Pushing On/Removing The Comb Attachments - SilverCrest SHBS 500 B2 Mode D'emploi

All manuals and user guides at all-guides.com

4. Items supplied

1 hair and beard trimmer
1 power unit 8
2 adjustable comb attachments 1:
Attachment 1: 1/3/6/9/12/15 mm
Attachment 2: 18/21/24/27/30/
33 mm
1 comb 12
1 scissors 13
1 cleaning brush 14
1 oil 15
1 storage pouch 16
1 set of operating instructions

5. Charging

NOTES:
• Before the device is used for the first
time, and during the following charging
procedures, the device should be
charged for 90 minutes in each case.
• When the batteries are almost empty,
the plug symbol 6 flashes in red. The
device can then only be used for a short
time without being connected to the
electricity supply.
1. Switch off the device with the on/off
switch 4 if necessary.
2. Connect the power unit 8 to the con-
nector 7 of the device.
3. Insert the power unit 8 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
4. The plug symbol 6 is lit red and the
battery is charged. When the battery is
fully charged, the battery symbol 5
flashes in blue. When the battery is ful-
ly charged, the device can be used for
approximately 60 minutes without be-
ing connected to the power supply.

6. Operation

Regardless of the charging state of the bat-
tery, the hair and beard trimmer can always
be mains-operated.
1. Before switching to mains operation,
ensure that the device is switched off.
2. Connect the power unit 8 to the con-
nection 7 of the device.
3. Insert the power unit 8 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
4. Switch on the device with the on/off
switch 4.
6.1 Pushing on/removing the
comb attachments
WARNING! Risk of injury!
Switch off the device before replacing
or changing the comb attachments 1.
Pushing on
• In order to attach a comb attachment 1,
push this over the guide rails on the side
of the device onto the comb attachment
fastener 9, until it is heard to click into
place.
Removing
1. Push the comb attachment 1 upwards us-
ing a moderate amount of force. The
comb attachment 1 is released from the
comb attachment fastener 9.
2. Remove the comb attachment 1.

6.2 Cutting hair

NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depend-
ing on the cutting angle.
7
GB