Icar RPC 5LSA-7LSA-8BSA-12BSA Guide Rapide page 7

For any subsequent modifications of the CT primary value, select the SETUP menu, then the M02 GENERAL menu. Select the parameter
P02.01 CT primary value. Repeat the above operations.
Main page
State of steps controlled by the controller. Black symbol: step inserted. Gray symbol: step not inserted.
Fattore di potenza medio settimanale, calcolato sugli ultimi 7 gg
Absent symbol: exit not used. Gray number: step temporarily not available (example: step just switched off).
Weekly true power factor, calculated on the last 7 days
Equipment inside temperature, fan status ( = stop; = start)
AUT= automatic mode; MAN= manual mode
Reactive power missing (if indication "+") or reactive power in surplus (if indication "-") compared to the set target cosφ.
Phase to phase voltage real time THD%
System current real time THD%, in the CT installation point
With the buttons it is possible to move from different available pages. With the button
buttons is accessed to the display of other steps that may be present in addition to those of the page 1/4.
Main menu
Select this icon to set the MANUAL MODE (MAN).
Select this icon to set the AUTOMATIC MODE (AUT).
Descriptive text field. It can be changed from the SETUP menu 
M01 UTILITY  P01.09 SITE ID
System realt time cosφ. IND= inductive, CAP= capacitive
Select the desired menu with the buttons
menu is colored in the negative, and appears in its center a text description.
is accessed to MAIN MENU page. With the
. Confirm with the button . The selected
p. 7 / 12