Kohler K-3901 Guide D'installation page 16

Spring
Clip
6. Install the Back Cover
NOTE: Install the cover when the water and power supply are routed through the floor. The cover is not
designed for use when the water or electrical power are connected to wall supplies.
Position the cover over the water supply and electrical supply holes.
Run the docking station cord through the slot in the cover and snap the cover into place on the
supply hose inlet.
Align the spring clip on the cover with the supply hose inlet.
NOTE: The clip will easily snap into place on the supply hose inlet. If there is significant resistance, make
sure the clip is not pushing the hose clip out of the way.
Lower the cover and snap the clip into place on the supply hose inlet.
1212876-2-B
Cover
Slot
Docking Station
Cord
Docking
Station Cord
16 Kohler Co.