Braun PrecisionSensor Pro Mode D'emploi page 9

To recall stored readings, first switch off the device.
Then press the memory button (B). Repeatedly
pressing the memory button will call up one by one
all stored readings (including status box information).
The number in the upper left corner of the display
indicates the memory position (01 being the oldest,
30 the most recent).
Holding down the memory button for more than a
second will delete all memory data completely.
After clearing the memory, the monitor will turn off
automatically.
Turning off the monitor
Press the «I/0» button to turn the monitor off.
Otherwise the monitor will turn off automatically after
2 minutes.
Measurement on patients in supine position
When taking a reading on a patient in supine position
the appropriate measurement position close to heart
level of the Braun PrecisionSensor™ Pro device is
normally achieved automatically. The active
positioning system is not needed in this case.
In order to take a correct measurement the position
sensor should be switched off for the measurement
(refer to «Pre-setting the position sensor»).
Pre-setting the position sensor
The active positioning system of the appliance
allows accurate and repeatable blood pressure
beep
measurements in the doctor's office. Therefore, the
position sensor is activated in the pre-settings at
the time of manufacture. We recommend that you
keep it activated. In certain cases, such as
measurements on persons lying down, it may be
necessary to de-activate the position sensor.
For this purpose, you will find a select button (D)
underneath the battery compartment cover.
9