Listening To The Radio - Sony ICF-SW1000T Mode D'emploi

Listening to the radio

1
ON/
OFF
2
FM/AM
3
AM BAND
+
4
8 EN
Basic Operations
1 2 3
4 5 6
7 8 9
0
To manually tune in to the desired broadcast staion, refer to
"Manual tuning" on page 14.
To immediately tune in to the desired broadcast station, refer to
"Direct tuning" on page 16.
To preset a broadcast station for instant recall, refer to "Preset
tuning" on page 17.
Press RADIO POWER ON/OFF.
The radio turns on.
Press FM/AM to select either FM
or AM.
Select AM to listen to SW, MW or LW.
When you select AM, press – 1¿
or ÷1 + while pressing AM
BAND to select MW, LW, or
meter band (SW)*.
Skip this step and proceed to step 4 if
you wish to listen to FM.
* For details on the meter band, refer to
"Meter bands and SW" on page 15.
Press and hold – 1¿ or ÷1 + and
release when scanning of the
frequency begins.
When a broadcast station is received
automatically, scanning pauses for
about 2 seconds. Then, scanning
resumes to tune in to the next
broadcast station.
Scanning repeats in a cycle within the
meter band frequency range (see page
15). Scanning during SSB reception
repeats in a cycle within the 150-29999
kHz frequency range.
—Scan tuning
1
VOLUME
2
3,4,5
3
FM
AM
AM
The minimum
frequency allocation for
each band is displayed.
PAGE
1
MHz
2
3
FWD
PAGE
1
2
kHz
3
FWD
PAGE
1
2
kHz
3
FWD