Installing The Thermostat - Aube TH114-A Guide Du Propriétaire

Owner's Guide

Installing the thermostat


Turn the heating system off at the main electrical panel.

Loosen the bottom screw and remove the thermostat faceplate from its
wallplate. (The screw cannot be completely removed.)

Connect the thermostat to the load and to the power supply (see page 7).
WARNING: For floor heating applications, you must install a separate
ground protection device at the main electrical panel or use a thermostat
with built-in ground protection device.

If the thermostat will be used in F or AF mode (see page 9), connect the
floor sensor (see page 8).

If you wish to connect a remote control device, see page 8.

Install the wallplate to the electrical box using the provided screws.

Set the configuration switches on the back of the faceplate (see page 9).

Install the faceplate back on the wall plate and tighten the screw. If there is
a sticker on the screen, peel it off.

Apply power to the heating system at the main electrical panel.
6
Faceplate
Wallplate