Installing The Thermostat - Aube TH115 Guide Du Propriétaire

Owner's Guide

Installing the thermostat


Turn the heating system off at the main electrical panel.

Loosen the bottom screw and remove the thermostat faceplate from its
wallplate. (The screw cannot be completely removed.)

Wire the thermostat. See typical wiring on pages 8-11.

If the thermostat will be used in F or AF mode (see page 12), connect the
floor sensor (see page 7).
WARNING: For floor heating applications, you must install a separate
ground protection device at the main electrical panel or use a thermostat
with built-in ground protection device.

Install the wallplate on the wall using the provided screws and wall
anchors.

Set the configuration switches (see page 12).

Install the faceplate back on the wallplate and tighten the screw. If there is
a sticker on the screen, peel it off.

Apply power to the heating system at the main electrical panel.
6
Faceplate
Wallplate