Dimplex CDFI-BX1500 Manuel Du Propriétaire page 7

Installation
2. Allow at least 4 ft. (122 cm) of service
cable for connecting a power supply wire
to the Opti-myst Cassette when installing
before finishing wall.
!
NOTE:
A 15 amp, 120 volt alternating
current (VAC) circuit is required. A dedicated
circuit is preferred but not essential in all
cases. A dedicated circuit will be required if,
after installation, the circuit breaker trips or
the fuse blows on a regular basis when the
heater is operating. Additional appliances
on the same circuit may exceed the current
rating of the circuit breaker.
Figure 1
!
NOTE:
Use minimum 14 AWG
supply cable with two insulated copper
conductors (white and black) and one
bare ground wire.
A
CDFI-
65"
BX1500
(165 cm)
Mounting
Flanges
A
B C
31.75" 14.7"
(80.5 cm) (37.3 cm)
Heater
Exhausst
C
E
D
D E
9.5" 4.8"
(24 cm) (12.2 cm) (39.3 cm)
B
F G
15.5" 16.2"
(41.2 cm)
G
F
I
H
H I
65.4" 32.3"
(166.2 cm) (82 cm)
7