Ribimex Ribiland PRBVB196TH Manuel D'instructions Et D'utilisation page 29

a. Check damaged parts
- Before further use or reuse of the product, it should be carefully checked to determine that it will operate
properly and perform its intended function.
- Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any
other conditions that may affect its operation.
- The safety devices and damaged parts must be repaired or exchanged by a recognized, specialist
workshop unless other information is mentioned in the manual.
- Damaged or illegible safety labels must be replaced.
b. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual, may
present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or persons.
c. Have your product repaired by qualified personnel
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in an
authorised service centre is recommended.
This product is in accordance with the relevant safety requirements. Repairs should only be carried out by
qualified persons using original spare parts, otherwise this may result in considerable danger to the user.
d. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the conditions
and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially for
any matters that are not referred in the above
e. Note: For specific maintenance and safety information about this product, consult the user's manual
provided with it. If it has been lost or misplaced, contact your local retailer for a replacement.
f. Important: The information contained in this instructions manual describes components available at the
time of publication. We reserve the right to make changes without prior notice and without obligation to
make alterations to components previously manufactured.
g. Residual risks
Residual risks may be reduced when the user carefully follows the "safety instructions" and the use of the
product "in accordance with its intended purpose" as well as all instructions stated in this manual.
Awareness and caution reduce risk of injury and damage.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
any way. Doing so might result in the product becoming damaged during
operation or the product becoming unable to operate properly.
HANDLING FUEL
1. The engine is designed to run on unleaded gasoline. WARNING: gasoline is
highly flammable. Never store cans of fuel or refill the tank of the unit in any
place where there is a boiler, stove, wood fire, electrical sparks, welding sparks,
or any other source of heat or fire which might ignite the fuel.
2. Never smoke while operating the unit or refilling its fuel tank.
3. When refilling the tank, always turn off the engine and allow it to cool down.
Take a careful look around to make sure that there are no sparks or open flames
anywhere nearby before refueling.
4. Wipe spilled fuel completely using a dry rag if any fuel spillage occurs during
refueling.
5. After refueling, screw the fuel cap back tightly onto the fuel tank and then
carry the unit to a spot 3 m or more away from where it was refueled before
turning on the engine.
6. Reminder: Gasoline must be stored and transported in approved containers.
Page 29 / 45