Philips sonicare ExpertClean 7300 Mode D'emploi page 20

20
English
Note: Your handle comes pre-charged for first use. After first use,
charge for at least 24 hours.
Charging on stand or Sanitizer
1 Plug the charger or sanitizer into an electrical outlet.
2 Place the handle on the charger or sanitizer.
3 The charger will charge your toothbrush until it is fully charged.
Charging with the travel case
Note: Only the following ExpertClean handles can be charged in the
charging travel case: HX972G, HX972K, HX972V, HX972P.
The HX number can be found on the bottom of your handle.
Note: The charging travel case requires a USB adapter to charge the
handle. The USB adapter is not included.
1 Connect the charging travel case to 5V DC input power either from:
- a UL-listed or certified to ANSI/UL 60950-1 personal
computer's standard USB connector or,
- a UL-listed or certified to ANSI/UL 60950-1 LPS power supply
with USB output port or,
- a UL-listed or certified 1310 Class 2 power supply.
2 The travel case will charge your toothbrush until your toothbrush is
fully charged.
Note: Charging the handle with the charging travel case may take
longer than on the charger.
Battery Status (handle on plugged in charger)
When the handle is placed on the charger, sanitizer or travel case ,
the battery light will flash green based on the current battery level.
Number of Flashing LEDs
1
2
3
Battery charging status
Low
Medium
High