Table des Matières
Publicité
Janome 2250 Instruction Manual
q
C
B C
www.toews.com
w
e
y
r
2
Attaching Buttons
q
Stitch selector:
w
Presser foot:
e
Thread tension:
r
Stitch length:
t
Stitch width:
t
y
Feed dog:
Tape the button over the placement mark.
A pin can be place on top of the foot to from a shank.
Set the pattern selector at " C ".
Align both holes of the button with the slot of the foot
and place the left hole of the button just below the
needle point.
Lower the foot and adjust the stitch width by turning the
zigzag width dial until the needle point comes just
above the right hole of the button.
Sew about five stitches and raise the needle.
To strengthen the shank, cut the threads leaving a
20 cm (8˝) tail.
Bring the needle thread down through the hole in the
button and wind it around the shank.
Draw the thread to the wrong side and knot.
44
C
Zigzag foot
1–3
Stitch length dial any number
(not necessary to adjust).
Set the stitch width as necessary
Dropped (See page 32).
QS2250 Owners Manual/ User Guide
Publicité
Table des Matières
