Adjusting The Screen Display (When Using A Digital Signal) - Sharp LL-T19D1 Mode D'emploi

Adjusting the screen display
Adjustments can be made using On Screen
Display (OSD) Menu provided.
On Screen Display for adjustment
If you are using Windows, open the Adjustment
Pattern on the accompanying Utility Disk. (p.16)
If your system is not Windows, you can not use the
Adjustment Pattern. Therefore display an image
that makes the entire screen light and adjust it
through checking visually its actual tone.
This chapter provides the procedure how to adjust
the screen by using Adjustment Pattern (for
Windows).
How to adjust
1.Press the MENU button.
The WHITE BALANCE Menu will be displayed.
At this point relevant menu options can be
adjusted.
Each time the MENU button is pressed the next
menu is selected. (WHITE BALANCE → MODE
SELECT → OSD Menu disappears)
Note:
- The OSD Menu automatically disappears
approximately 30 seconds after the last
command.
(When using a digital signal)
WHITE BALANCE Menu
Notes:
- On settings other than [STD] not all gradations
can be displayed. To display all gradations, set to
[STD].
- If [DISPLAY MODE] is set to [OFFICE], [sRGB] or
[VIVID], no other setting than [STD] can be
selected.
- Use the buttons to select [COOL], [·], [STD],
[·], [WARM] or [USER].
- Selecting [USER] will display the setting values
for [R-CONTRAST], [G-CONTRAST] and [B-
CONTRAST], in order to make fine adjustments.
- Use the / MODE button to select
[R-CONTRAST], [G-CONTRAST] and
[B-CONTRAST].
- To go to the next menu: MENU button
COOL ....... Color tone bluer than standard
• ............. Color tone slightly bluer than standard
STD .......... Color tone standard setting
• ............. Color tone slightly redder than standard
WARM ...... Color tone redder than standard
USER
R-CONTRAST .....
G-CONTRAST .....
B-CONTRAST .....
20
button for blue-green
button for red
button for purple
button for green
button for yellow
button for blue