Safety Instructions; Important Safety Instructions; Electrical Risks - Pentair MYERS MWH50 Série Manuel D'installation Et D'utilisation

SAFETY INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS - This manual contains important
instructions that should be followed during installation,
operation, and maintenance of the product. Save this manual
for future reference.
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
words and be alert to the potential for personal injury!
indicates a hazard which, if not avoided, will result in
death or serious injury.
indicates a hazard which, if not avoided, could result
in death or serious injury.
indicates a hazard which, if not avoided, could result
in minor or moderate injury.
NOTICE addresses practices not related to personal injury.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.

ELECTRICAL RISKS

Pumps with a single seal are supplied with a grounding
conductor and grounding-type attachment plug on the power
cord. To reduce the risk of electric shock:
Be certain that it is connected only to a properly grounded,

grounding-type receptacle.
DO NOT cut off ground pin or use an adapter fitting.

DO NOT use an extension cord with this pump.

Entire plug may be cut off if a control panel is used.

When wiring this pump follow all local electrical and safety

codes and ordinances as well as the most recent National
Electric Code (NEC-ANSI/NFPA 70).
All pumps have a GROUND WIRE that is connected to a screw
in the metal motor housing. This wire goes to the receptacle
or control box which must be connected to a good outside
GROUND such as a metal water pipe or GROUND STAKE driven
at least 8 feet into the ground.
23822A278 (02-13-20)
WHEN OVERLOAD CURRENT PROTECTION IS PROVIDED BY
INSTALLER:
USE WITH APPROVED MOTOR CONTROL THAT MATCHES
MOTOR INPUT IN FULL LOAD AMPERES WITH OVERLOAD
ELEMENT(S) SELECTED OR ADJUSTED IN ACCORDANCE WITH
CONTROL INSTRUCTIONS.
WHEN MOTOR HAS BUILT-IN OVERLOAD PROTECTION:
USE WITH APPROVED MOTOR CONTROL THAT MATCHES
MOTOR INPUT IN FULL LOAD AMPERES.
3